Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 1 Static Route Configuration Commands
3Com Corporation
1-19
mask: Dotted decimal subnet mask or subnet mask length.
Description
Use the display loadsharing ip address command to view the statistics about the
unbalanced load sharing based on interface bandwidth, including the number and ratio
of the packets sent from the interfaces related to the equal-cost routes to a network
address.
You can view these equal-cost routes using the display fib command.
Related command: display fib.
Example
# Display information about load sharing on all the interfaces corresponding to the
equal-cost routes to the network 10.2.1.0/24.
[3Com ] display loadsharing ip address 10.2.1.0 24
There are/is totally 3 route entry(s) to the same destination network.
Nexthop Packet(s) Bandwidth[KB] Flow(s) Interface
10.1.1.2 763851 100000 0 Ethernet0/0/0
10.1.2.2 1193501 155000 0 Atm1/0/0
10.1.3.2 15914 2048 0 Serial2/0/0
BandWidth:48:75:1
Packets:47:74:1
Flows:0:0:0
1.3.3 loadbandwidth
Syntax
loadbandwidth bandwidth
undo loadbandwidth
View
Interface (excluding logical interfaces) view
Parameter
bandwidth: Load bandwidth in kbps on the current interface, in the range 0 to
1,000,000.
Description
Use the loadbandwidth command to allocate load bandwidth to the interface.
Use the undo loadbandwidth to restore the default load bandwidth of the interface,
that is, the physical bandwidth.