Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 2 RIP Configuration Commands
3Com Corporation
2-2
2.1.2 debugging rip
Syntax
debugging rip { packet [ interface type number ] | receive | send }
View
User view
Parameter
packet: Enables the RIP packets debugging.
interface type number: Enables RIP packet debugging on the specified interface.
receive: Enables the RIP receiving packets debugging.
send: Enables the RIP sending packets debugging.
Description
Use the debugging rip command to enable RIP debugging.
Use the undo debugging rip command to disable RIP debugging.
Users can learn the current information of receiving and sending RIP packets on each
interface by using this command.
Example
# Enable RIP packet debugging.
<3Com > debugging rip packet
2.1.3 default cost
Syntax
default cost value
undo default cost
View
RIP view
Parameter
value: Default routing cost to be set, ranging from 1 to 16.The default value is 1.
Description
Use the default cost command to configure the default routing cost of a redistributed
route.
Use the undo default cost command to restore the default value.