Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 2 RIP Configuration Commands
3Com Corporation
2-9
2.1.10 host-route
Syntax
host-route
undo host-route
View
RIP view
Parameter
None
Description
Use the host-route command to control the RIP to accept the host route.
Use the undo host-route command to reject the host route.
By default, router accepts the host route.
In some special cases, RIP receives a great number of host routes in the same network
segment. These routes cannot help the path searching much but occupy a lot of
resources. In this case, the undo host-route command can be used to reject host
routes.
Example
# Configure RIP to reject a host route.
[3Com -rip] undo host-route
2.1.11 import-route
Syntax
import-route protocol [ allow-ibgp ] [ cost value ] [ route-policy route-policy-name ]
undo import-route protocol
View
RIP view
Parameter
protocol: Specifies the source routing protocol to be redistributed by RIP. At present,
RIP can redistribute the following routes: direct, ospf, ospf-ase, ospf-nssa, static,
and bgp and isis.
allow-ibgp: Optional when the protocol argument is set to BGP. Whereas the
import-route bgp command redistributes only EBGP routes, the import-route bgp