Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 2 RIP Configuration Commands
3Com Corporation
2-11
vpn-instance-name: Associates the specified VPN instance with the IPv4 address
family. Enter the MBGP address family view of RIP with this parameter.
Description
Use the ipv4-family command to enter MBGP address family view of RIP.
Use the undo ipv4-family command to cancel all configurations in extended address
family view.
ipv4-family command is used to enter the MBGP address family view. In this view,
parameters related to address family can be configured for RIP.
undo ipv4-family command is only used in RIP view.
The ipv4-family vpn-instance command is used for BGP/MPLS VPN. For related
description, refer to “MPLS VPN“ section in module “MPLS” chapter of this manual.
Related command: display rip vpn-instance.
Example
# Enter the RIP MBGP address family view.
[3Com ] ip vpn-instance xhy
[3Com -vpn-xhy] route-distinguisher 100:1
[3Com -rip] ipv4-family vpn xhy
[3Com -rip-af-vpn-instance]
2.1.13 network
Syntax
network network-address
undo network network-address
View
RIP view
Parameter
network-address: Address of the network enabled/disabled. It can be IP network
address of any interface. Alternatively, it can be 0.0.0.0 to enable all network segments.
Description
Use the network command to enable Routing Information Protocol (RIP) on the
interface.
Use the undo network command to cancel the RIP on the interface.
By default, RIP is disabled on any interface.