Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 2 RIP Configuration Commands
3Com Corporation
2-13
Example
# Specify the sending destination address 202.38.165.1.
[3Com -rip] peer 202.38.165.1
2.1.15 preference
Syntax
preference value
undo preference
View
RIP view
Parameter
value: Preference level, ranging from 1 to 255. By default, the value is 100.
Description
Use the preference command to configure the route preference of RIP.
Use the undo preference command to restore the default preference.
Every routing protocol has its own preference. Its default value is determined by the
specific routing policy. The preference will finally determine the routing algorithm to
obtain the optimal route in the IP routing table. This command can be used to modify
the RIP preference manually.
Example
# Specify the RIP preference as 20.
[3Com -rip] preference 20
2.1.16 reset
Syntax
reset
View
RIP view
Parameter
None