Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 2 RIP Configuration Commands
3Com Corporation
2-14
Description
Use the reset command to reset the system parameters of RIP.
When you need to re-configure parameters of RIP, this command can be used to
restore the default setting.
Example
# Reset the RIP system.
[3Com -rip] reset
2.1.17 rip
Syntax
rip
undo rip
View
system view
Parameter
None
Description
Use the rip command to enable the RIP and enter the RIP view.
Use the undo rip command to cancel RIP.
By default, the system does not run RIP.
To enter the RIP view to configure various RIP global parameters, RIP should be
enabled first. Whereas the configuration of parameters related to the interfaces is not
restricted by enabling/disabling RIP.
Caution:
You can execute the undo rip command in both system view and interface view, which
will lead to deletion of all RIP-related commands.
Example
# Enable the RIP and enter the RIP view.
[3Com ] rip