Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 2 RIP Configuration Commands
3Com Corporation
2-18
Use the rip metricout value all-route command to enable RIP to send routes out the
interface with an additional route metric added. This command applies to locally
redistributed routes in addition to those locally learned and learned from other routers.
Use the undo rip metricout command to restore the default value of this additional
route metric.
The rip metricout value command will override the previously configured rip
metricout value all-route command, if there is any.
Related command: rip metricin.
Example
# Enable RIP to send routes out interface Serial 6/0/0 all with an additional route metric
added.
[3Com -Serial6/0/0] rip metricout 10 all-route
# When RIP sends routes out interface Serial 6/0/0, enable it to add an additional route
metric to the routes both locally learned and learned from other routers.
[3Com -Serial6/0/0] rip metricout 10
# Restore the default additional route metric value.
[3Com -Serial6/0/0] undo rip metricout
2.1.22 rip output
Syntax
rip output
undo rip output
View
Interface view
Parameter
None
Description
Use the rip output command to configure an interface to transmit RIP packets to the
external.
Use the undo rip output command to cancel an interface to transmit RIP packets to
the external.
By default, RIP packets at all interfaces (except loopback interface) can be transmitted.
This command is used in cooperation with the other two commands: rip input and rip
work. Functionally, rip work is equivalent to rip input & rip output. The latter two