Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 2 RIP Configuration Commands
3Com Corporation
2-20
2.1.24 rip triggered
Syntax
rip triggered
undo rip triggered
View
Interface view
Parameter
None
Description
Use the rip triggered command to enable trigger RIP (TRIP).
Use the undo rip triggered command to disable TRIP.
TRIP only runs on PPP, frame relay, and X.25.
Routers are used on connection-oriented networks to allow potential connectivity to
many remote destinations. Circuits on the WAN are established on demand and are
relinquished when traffic subsides. Depending on the application, the connection
between any two sites for user data could be short and relatively infrequent.
Periodic updates are suppressed over the interface on which this feature is enabled.
Therefore, you can save money on demand circuit for which you are charged for usage.
Whenever, routing information needs to be exchanged over demand circuits using RIP,
or triggered RIP it should be enabled.
Example
# Enable TRIP.
[3Com ] serial 6/0/0
[3Com -Serial6/0/0] rip triggered
2.1.25 rip version
Syntax
rip version { 1| { 2 [ broadcast | multicast ] } }
undo rip version
View
Interface view