Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 1 System Maintenance and Management
Commands
3Com Corporation
1-30
different default settings for log, trap, and debugging information. If a module has no
explicit configuration record in the channel, the default configuration record is used.
When adding a new or duplicate record, you need to specify its log, trap, and debug
information levels if the default levels are not desired.
Example
# Output IP module’s log information at emergencies and lower levels through the
SNMP channel.
[3com] info-center source ip channel snmpagent log level emergencies
# Remove the setting of the CMD module in the SNMP channel.
[3com] undo info-center source cmd channel snmpagent
1.3.16 info-center synchronous
Syntax
info-center synchronous
undo info-center synchronous
View
System view
Parameter
None
Description
Use the info-center synchronous command to enable synchronous terminal output.
Use the undo info-center synchronous command to disable synchronous terminal
output.
When you are editing a command line, the output of system information may interrupt
your work. With synchronous terminal output enabled, the system can re-display the
input that you are editing after the system information output is completed.
By default, synchronous terminal output is disabled.
Example
# Enable synchronous terminal output.
[3com] info-center synchronous
Current IC terminal output sync is on