Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 3 OSPF Configuration Commands
3Com Corporation
3-37
%Apr 12 17:15:09:210 2005 UA02 RM/5/RTLOG:OSPF-ADJCHANGE:Process 1,Adjacency
To 1.1.1.1 (Serial4/0/0) from Down to Down
Information about adjacency changes is in boldface.
3.1.31 multi-path-number
Syntax
multi-path-number number
undo multi-path-number
View
OSPF view
Parameter
number: Number of equal-cost routes, in the range 1 to 3. It defaults to 3.
Description
Use the multi-path-number command to configure maximum number of OSPF
equal-cost routes.
Use the undo multi-path-number command to restore the default.
Example
# Set the number of OSPF equal-cost routes to 2.
[3Com -ospf-1] multi-path-number 2
3.1.32 network
Syntax
network ip-address wildcard
undo network ip-address wildcard
View
OSPF area view
Parameter
ip-address: Address of the network segment where the interface locates.
wildcard: IP address wildcard mask, which is similar to the reversed form of the mask of
IP address. But when configure this parameter to type it as mask of IP address, it could
be translated as wildcard mask by VRP system.