Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 3 OSPF Configuration Commands
3Com Corporation
3-56
Keywords Description
virifstatechange
Enables the
VirtualInterfaceStateChange trap
packets
viriftxretransmit
Enables the
VirtualInterfaceTxRetransmitPacket trap
packets
virnbrstatechange
Enables the
VirtualNeighborStateChange trap
packets
Description
Use the snmp-agent trap enable ospf command to enable the TRAP function of
OSPF.
Use the undo snmp-agent trap enable ospf command to disable the TRAP function.
This command takes no effect on the OSPF process enabled after its execution.
By default, no OSPF process is enabled to transmit TRAP packets.
For detailed configuration of SNMP TRAP, refer to “system management” section in this
manual.
Example
# Enable TRAP function of OSPF process 100.
<3Com > snmp-agent trap enable ospf 100
3.1.53 spf-schedule-interval
Syntax
spf-schedule-interval interval
undo spf-schedule-interval
View
OSPF view
Parameter
Interval: SPF calculation interval of OSPF, which is in seconds in the range of 1 to 10.
The default value is 5 seconds.
Description
Use the spf-schedule-interval command to configure the route calculation interval of
OSPF.