Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 4 Integrated IS-IS Configuration Commands
3Com Corporation
4-6
Parameter
verbose: If this parameter is used, the details of the interface will be displayed.
Description
Use the display isis interface command to view the information of the IS-IS enabled
interface.
This command views the information of the IS-IS enabled interface, including interface
name, IP address, link state of the interface and so on. Besides displaying all the
information shown by the display isis interface command, the display isis interface
verbose command displays such information about the IS-IS parameters of the
interface as CSNP packet broadcast interval, Hello message broadcast interval and
number of invalid Hello messages.
Example
# Display the information about the IS-IS enabled interface.
<3Com > display isis interface
Interface IP Address Id Link.Sta IP.Sta MTU Type DIS
Ethernet1/0/0 2.1.1.12 001 Up Up 1497 L12 No/No
# Display the details of the IS-IS enabled interface.
<3Com > display isis interface verbose
Interface IP Address Id Link.Sta IP.Sta MTU Type DIS
Ethernet1/0/0 2.1.1.12 001 Up Up 1497 L12 No/No
Secondary IP Address(es) :
Csnp-Interval : L1 10 L2 10
Hello-Interval : L1 10 L2 10
Hold Time : L1 30 L2 30
Lsp Interval : 1
Cost : L1 10 L2 10
Priority : L1 64 L2 64
Retransmit Interval : 5
4.1.7 display isis lsdb
Syntax
display isis lsdb [ l1 ] [ l2 ] [ level-1 ] [ level-2 ] [ local ] [ verbose ] [ LSPID ]
View
Any view
Parameter
l1 and Level-1: Both refer to the link state database of Level-1.