Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 4 Integrated IS-IS Configuration Commands
3Com Corporation
4-16
View
System view
Parameter
tag: Name given to the IS-IS process. The name length should be no longer than 128
characters. It can be 0, which means null.
Description
Use the isis command to enable the corresponding IS-IS routing process and enter the
IS-IS view.
Use the undo isis command to cancel the specified IS-IS routing process.
By default, IS-IS routing process is not started
For the normal operation of the IS-IS protocol, the isis command must be used to
enable the IS-IS process. Then the network-entity command is used to set a Network
Entity Title (NET) for the router. And, at last, the isis enable command is used to
enable each interface on which the IS-IS process runs. The IS-IS protocol is actually
enabled upon the completion of these configurations.
 Note:
Only one IS-IS routing process can be started on one router.
Related command: isis enable and network-entity.
Example
# Start an IS-IS routing process, in which the system ID is 0000.0000.0002 and the
area ID is 01.0001.
[3Com ] isis
[3Com -isis] network-entity 01.0001.0000.0000.0002.00
4.1.19 isis authentication-mode
Syntax
isis authentication-mode { simple | md5 } password [ { level-1 | level-2 } [ ip | osi ] ]
undo isis authentication-mode { simple | md5 } password [ { level-1 | level-2 } [ ip |
osi ] ]
View
Interface view