Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 4 Integrated IS-IS Configuration Commands
3Com Corporation
4-26
4.1.30 isis timer retransmit
Syntax
isis timer retransmit seconds
undo isis timer retransmit
View
Interface view
Parameter
seconds: Specifies the retransmission interval of LSP packets, with the range from 0 to
300 and the default value is 5 seconds.
Description
Use the isis timer retransmit command to configure the LSP retransmission interval
over the point-to-point link.
Use the undo isis timer retransmit command to restore the default setting.
Use this parameter cautiously when setting this parameter to avoid unnecessary
retransmission.
The response is required when sending LSP packets on the p2p link, not the broadcast
link, and therefore this command is unnecessary for the broadcast link.
Related command: isis timer lsp.
Example
# Set the LSP retransmission interval to 10 seconds on Interface serial1/0/0.
[3Com ] interface serial1/0/0
[3Com -Serial1/0/0] isis timer retransmit 10
4.1.31 is-level
Syntax
is-level { level-1 | level-1-2 | level-2 }
undo is-level
View
IS-IS view
Parameter
level-1: Configures the router to operate at Level-1, only calculate the intra-area routes
and maintain the LSDB of L1.