Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 4 Integrated IS-IS Configuration Commands
3Com Corporation
4-32
View
IS-IS view
Parameter
None
Description
Use the set-overload command to configure overload flag bit for the current router.
Use the undo set-overload command to reset the overload flag bit.
By default, no overload bit is set.
If a router is configured with the overload bit, it will be ignored by other routers in SPF
calculation. (However the directly connected routes will not be ignored.)
When the overload threshold is set, other routers should not send this router the
packets which should be forwarded by it.
Example
# Set overload flag bit on the current router.
[3Com -isis] set-overload
4.1.39 silent-interface
Syntax
silent-interface interface-type interface-number
undo silent-interface interface-type interface-number
View
IS-IS view
Parameter
interface-type: Specifies the interface type.
interface-number: Specifies the interface number.
Description
Use the silent-interface command to disable a specified interface to transmit IS-IS
packet.
Use the undo silent-interface command to enable the interface to transmit IS-IS
packet.
By default, all the interface are allowed to transmit/receive IS-IS packets.