Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 5 BGP Configuration Commands
3Com Corporation
5-37
Use the undo log-peer-change command to turn off the BGP adjacency changes
output switch.
By default, BGP adjacency changes output switch is turned off.
After the BGP adjacency changes output switch is turned on, BGP adjacency changes
will be output to the configuration terminal until the switch is turned off.
Example
# Turn on the BGP adjacency changes output switch on the current router.
[3Com -bgp] log-peer-change
5.1.37 network
Syntax
network ip-address [ address-mask ] [ route-policy route-policy-name ]
undo network ip-address [ address-mask ] [ route-policy route-policy-name ]
View
BGP view
Parameter
ip-address: Network address for BGP to advertise.
address-mask: Mask of the network address.
route-policy-name: Route-policy applied to the advertised route.
Description
Use the network command to configure the network routes advertised by the local
BGP system.
Use the undo network command to cancel the existing configuration.
By default, no route is advertised by the local BGP system.
Example
# Advertise the route through network segment 10.0.0.0/16.
[3Com -bgp] network 10.0.0.1 255.255.0.0
5.1.38 peer advertise-community
Syntax
peer group-name advertise-community
undo peer group-name advertise-community