Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 5 BGP Configuration Commands
3Com Corporation
5-43
By default, this feature is disabled.
Example
# Allow to establish EBGP connection with peer group "test" on an indirectly connected
network.
[3Com -bgp] peer test ebgp-max-hop
5.1.46 peer enable
Syntax
peer { group-name | peer-address } enable
undo peer { group-name | peer-address } enable
View
BGP unicast address family view, IPv4 multicast sub-address family view, VPNv4
address family view, L2VPN address family view
Parameter
group-name: Specifies the name of the peer group.
peer-address: Specifies the IP address of the peer.
Description
Use the peer enable command to enable the specified peer (group).
Use the undo peer enable command to disable the specified peer (group).
Note that the peer peer-address enable command can be configured in unicast
address family view only. Use this command to disable the unicast function of the peer.
You can delete the peer from the group in the corresponding address to disable its
multicast function or VPNv4 function.
By default, BGP peer (group) is enabled in unicast address family, but disabled in VPN
and MBP address families.
If the specified peer/peer group is disabled, the router will not exchange routing
information with the specified peer (group).
Example
# Deactivate the specified peer.
[3Com ] bgp 180
[3Com -bgp] peer 18.10.0.9 as-number 180
[3Com -bgp] undo peer 18.10.0.9 enable
# Configure a peer and activate it in VPNv4 unicast address family view.
[3Com ] bgp 100