Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 1 Basic Configuration Commands
3Com Corporation
1-4
view view: Specifies a view.
commandkey: Command to be set in the specified view.
Description
Use the command-privilege command to assign a command level to the commands
in the specified view.
Use the undo command-privilege view command to restore the default.
Command privilege falls into four levels: visit, monitor, system, and manage, which are
identified by 0 through 3.
For a user logs onto the router from a user interface, the command level that the user
can access can be the one administratively assigned to the user or the one assigned to
the user interface, whichever is smaller. For more information on how to assign
command level to a user interface, refer to “Chapter 4 User Interface Configuration
Commands” in V 2.41 Command Manual – System Management.
The following table describes the default level of the commands.
Table 1-1 Default level of the commands
Command level Commands
Visit (0) ping, tracert, telnet
Monitor (1)
display, debugging
System (2) Configuration commands
Manage (3)
Key settings, FTP, Xmodem, TFTP, file system
operation commands
Example
# Set the command level of the interface command to 0.
[3Com] command-privilege level 0 view system interface
1.1.5 cpu-usage cycle
Syntax
cpu-usage cycle { 5sec | 1min | 5min | 72min } [ slave | slot slot-num ]
View
System view
Parameter
5sec: Sets the statistic interval to five seconds.