Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 6 IP Routing Policy Configuration
Commands
3Com Corporation
6-6
Example
# Apply the local preference level of route information as 130 when this apply clause is
used for setting route information attribute.
[3Com -route-policy] apply local-preference 130
6.1.8 apply origin
Syntax
apply origin { igp | egp as-number | incomplete }
undo apply origin
View
Routing policy view
Parameter
igp: Sets the BGP route information source as internal route
egp: Sets the BGP route information source as external route
as-number: Specifies AS number of external route.
incomplete: Sets the BGP route information source as unknown source.
Description
Use the apply origin command to set the routing source of BGP routing information.
Use the undo apply origin command to cancel the apply clause.
Related command: if-match interface, if-match acl, if-match ip-prefix, if-match ip
next-hop, if-match cost, if-match tag, route-policy, apply ip-address, apply
local-preference, apply cost, and apply tag.
Example
# Display how to define one apply clause. When it is used for setting routing information
attribute, it sets the routing source of the routing information as igp.
[3Com -route-policy] apply origin igp
6.1.9 apply tag
Syntax
apply tag value
undo apply tag