Command Reference Guide

3Com Router 3000 Ethernet Family

Chapter 1 Multicast Common Configuration

Commands

3Com Corporation

1-5

Total 1 entry

(10.10.1.2, 225.1.1.1)

UpTime: 00:01:28, Timeout in 278 sec

Upstream interface: Ethernet0/0/0(10.10.1.20)

Downstream interface list:

LoopBack0(20.20.20.30), Protocol 0x1: IGMP

1.1.6 display multicast routing-table static

Syntax

display multicast routing-table static [ config ] [ source-address [ mask |

mask-length ] ]

View

Any view

Parameter

config: When this parameter is chosen, all the routing information configured will be

displayed. If this parameter is not chosen, only effective routing information is

displayed.

source-address: IP address of the multicast source.

mask: Mask.

mask-length: Length of mask. Because “1”s in 32-bit mask are required to be

continuous, the mask in dotted decimal notation format can be replaced by mask-length

(mask-length is the number of continuous “1”s in the mask).

Description

Use the display multicast routing-table static command to view the configuration

information of static multicast route.

Example

# Display the configuration information of static multicast route.

<3Com>display multicast routing-table static

100.10.0.0/16

RPF interface = 10.10.1.20(Ethernet0/0/0), RPF neighbor = 10.10.1.20

Matched routing protocol = <none>, route-policy = <none>, preference = 1

Running config = ip rpf-route-static 100.10.0.0 16 Ethernet0/0/0 preference