Command Reference Guide

3Com Router 3000 Ethernet Family

Chapter 1 Multicast Common Configuration

Commands

3Com Corporation

1-9

By default, no minimum TTL value for multicast forwarding is configured.

Example

# Configure the minimum TTL value for multicast forwarding to 8.

[3Com-Ethernet1/0/1] multicast minimum-ttl 8

1.1.10 multicast packet-boundary

Syntax

multicast packet-boundary acl-number

undo multicast packet-boundary

View

Interface view

Parameter

acl-number: Number of basic or advanced ACL, ranging from 2000 to 3999.

Description

Use the multicast packet-boundary command to configure a multicast forwarding

boundary.

Use the undo multicast packet-boundary command to remove the multicast

forwarding boundary configured.

By default, no multicast forwarding boundary is configured.

You can set boundary conditions for multicast packets on an interface via basic or

advanced Access Control List (ACL). Packets denied by the ACL will be discarded. The

source address of a multicast packet can be filtered through the basic ACL. Both the

source address and the destination address (source group address) of a multicast

packet can be filtered through the advanced ACL.

Example

# Set boundary conditions for multicast packets through the basic ACL 2001.

[3Com-Ethernet1/0/1] multicast packet-boundary 2001

1.1.11 multicast route-limit

Syntax

multicast route-limit limit

View

System view