Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide Chapter 3 PIM Configuration Commands
3Com Corporation
3-18
source-address: Multicast source address.
mask source-mask: Address mask of multicast source.
source-mask-length: Address mask length of multicast source.
null: Route entry with null incoming interface.
incoming-interface: Incoming interface of the route entry in PIM routing table.
interface-type interface-number: Interface type and interface number.
Description
Use the reset pim routing-table command to clear PIM route entry.
The sequence of group-address and source-address can be reversed, but the input
group-address and source-address must be valid. Otherwise, the system will prompt
input error.
If group-address is configured to 244.0.0.0/24 and source-address to RP address (in
which, group address may have mask but the calculation result of the two must be
224.0.0.0, while source address has no mask), it indicates only (*, *, RP) entry is
deleted.
If group-address is configured to a group address and source-address to 0 (in which,
group address may have mask while source address has no mask), it indicates only (*,
G) entry is deleted.
After this command is executed, not only the multicast route entry is deleted from PIM,
but also the corresponding route entry or forwarding entry in the multicast kernel
routing table and MFC is deleted.
Related command: reset multicast routing-table, reset multicast forwarding-table,
display pim routing-table.
Example
# Clear the route entry with group address of 225.5.4.3 in PIM routing table.
<3Com> reset pim routing-table 225.5.4.3
3.1.23 source-policy
Syntax
source-policy acl-number
undo source-policy
View
PIM view