Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide Chapter 4 MSDP Configuration Commands
3Com Corporation
4-6
Description
Use the import-source command to configure which (S, G) entries in the domain need
to be advertised when a MSDP originates an SA message.
Use the undo import-source command to remove the configuration.
By default, all the (S, G) entries in the domain are advertised by the SA message.
Besides controlling SA messages creation, you can filter the forwarded SA messages
by the commands peer sa-policy import and peer sa-policy export.
Example
# Configure which (S, G) entries from the multicast routing table will be advertised in SA
messages originated by the MSDP peer.
<3Com> system-view
[3Com] acl number 3101
[3Com-acl-adv-3101] rule permit ip source 10.10.0.0 0.0.255.255 destination
225.1.0.0 0.0.255.255
[3Com-acl-adv-3101] quit
[3Com] msdp
[3Com-msdp] import-source acl 3101
4.1.8 msdp
Syntax
msdp
undo msdp
View
System view
Parameter
None
Description
Use the msdp command to enable MSDP and enter the MSDP view.
Use the undo msdp command to clear all configurations of MSDP, release all
resources that MSDP occupies, and restore the initial state.
Related command: peer.
Example
# Clear all configurations of MSDP.
<3Com> system-view