Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide Chapter 4 MSDP Configuration Commands
3Com Corporation
4-9
Item Description
Next-Hop Router Address: 0.0.0.0
If the parameter next-hop-info is used,
Peer-RPF neighbor address will be
displayed.
Count of SA messages received for this
(S,G,RP)
Number of SA messages received for
tracing this (S, G, RP) entry.
Count of encapsulated data packets
received for this (S,G,RP)
Number of encapsulated data packets
received for tracing this (S, G, RP) entry.
SA cache entry uptime Present time of SA cache entry.
SA cache entry expiry time Expiry time of SA cache entry.
Peering Uptime: 10 minutes
Time for which the local router performs
Peering session with Peer-RPF
neighbor.
Count of Peering Resets Number of Peering session resets.
4.1.10 originating-rp
Syntax
originating-rp interface-type interface-number
undo originating-rp
View
MSDP view
Parameter
interface-type: Interface type.
interface-number: Interface number.
Description
Use the originating-rp command to allow a MSDP to use the IP address of specified
interface as the RP address in the SA message originated.
Use the undo originating-rp command to remove the configuration.
By default, the RP address in the SA message is the RP address configured by PIM.
Configure logical RP by using this command.
Example
# Configure IP address of the interface Ethernet1/0/0 as the RP address in the SA
message originated.
<3Com> system-view