Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide
Chapter 6 Multicast Static Route Configuration
Commands
3Com Corporation
6-2
Description
Use the display multicast routing-table static command to view the active multicast
static routes.
If no multicast source address is specified, all active multicast static routes will be
displayed.
Related command: display multicast routing-table static config.
Example
# Display all active multicast static routes.
<3Com> display multicast routing-table static
22.22.0.0/16 [inactive]
RPF interface = serial0/0/0, RPF neighbor = 66.55.99.88
Matched routing protocol = = <none>, route-policy = <none>, preference = 1
Running config = ip mroute 22.22.0.0 16 66.55.99.88 preference 1
# Display the multicast static routes that exactly match the address 10.10.0.0/16.
<3Com> display multicast routing-table static 10.10.0.0 255.255.0.0
6.1.3 display multicast routing-table static config
Syntax
display multicast routing-table static config [ source mask ]
View
Any view
Parameter
source: IP address of multicast source (unicast address).
mask: IP address mask of multicast source.
Description
Use the display multicast routing-table static config command to view multicast
static routes configured.
If no multicast source address is specified, all configured multicast static routes will be
displayed.
Related command: display multicast routing-table static.
Example
# Display all the configured multicast static routes.
<3Com> display multicast routing-table static config