Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide Chapter 1 MPLS Basic Configuration Commands
3Com Corporation
1-5
In Discard Packets of Mpls interface is: 0
The statistics of interface out :
Out Octets of Mpls interface is: 0
Out Packets of Mpls interface is: 0
Out Errors of Mpls interface is: 0
Out Discard Packets of Mpls interface is: 0
The statistics of interface : Serial6/0/1
The statistics of interface in :
In Octets of Mpls interface is: 0
In Packets of Mpls interface is: 0
In Errors of Mpls interface is: 0
In Discard Packets of Mpls interface is: 0
The statistics of interface out :
Out Octets of Mpls interface is: 0
Out Packets of Mpls interface is: 0
Out Errors of Mpls interface is: 0
Out Discard Packets of Mpls interface is: 0
1.1.6 lsp-trigger
Syntax
lsp-trigger { all | ip-prefix ip-prefix }
undo lsp-trigger { all | ip-prefix [ ip-prefix ] }
View
MPLS view
Parameter
all: Triggers LSPs at any route.
ip-prefix: Triggers LSPs only at the routes matching the specified IP prefix list.
ip-prefix: IP prefix list, ranging from 1 to 19.
Description
Use the lsp-trigger command to configure topology-triggered LSP creation policy.
Use the undo lsp-trigger command to remove the filtering conditions specified by
parameters and disable LSP trigger creation at any route.
By default, all kinds of routing protocols are filtered out.