Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide Chapter 1 MPLS Basic Configuration Commands
3Com Corporation
1-23
[3Com -Ethernet0/0/0.1] mpls ldp password simple 123
1.2.15 mpls ldp path-vectors
Syntax
mpls ldp path-vectors pv-number
undo mpls ldp path-vectors
View
System view
Parameter
pv-number: Maximum value of path vector, ranging from 1 to 32.
Description
Use the mpls ldp path-vectors command to set the maximum value of path vector.
Use the undo mpls ldp path-vectors command to restore the default maximum value
of path vector.
By default, pv-number is 32.
This command should be configured before LDP is enabled on any interface. Its value,
which depends on actual networking situation, decides the loop detection speed in LSP
creation.
Related command: mpls ldp loop-detection and mps ldp hops-count.
Example
# Set the maximum value of path vector to 23
[3Com ] mpls ldp path-vectors 23
# Restore the default maximum value of path vector.
[3Com ] undo mpls ldp path-vectors
1.2.16 mpls ldp remote-peer
Syntax
mpls ldp remote-peer Index
undo mpls ldp remote-peer Index
View
System view or remote-peer view