Command Reference Guide

3Com Router 3000 Ethernet Family
Command Reference Guide Chapter 1 MPLS Basic Configuration Commands
3Com Corporation
1-27
Parameter
ip-address: IP address of a remote peer.
Description
Use the remote-ip command to configure a remote IP address. The address should be
the LSR ID of the remote LSR. As remote peers adopt LSR ID as their transport
addresses, the last two remote peers use their LSR ID as their transport addresses for
creating TCP connection.
remote-peer command is mainly used for extension discovery mode to establish
session with peers that are not directly connected with the links.
Related command: mpls ldp remote-peer.
Example
# Configure the address of remote-peer.
[3Com ] mpls ldp remote-peer 12
[3Com -remote-peer12] remote-ip 192.168.1.