User Manual

Removal and Replacement Procedures
9. Remove both plastic rivets from the PCI backplane:
a. From inside the chassis, use a pointed tool to push the center pin out through the front
of the rivet.
b. Pull the pin completely from the rivet and set aside.
c. Remove the rivet.
Figure 2-41: Removing the PCI backplane rivets
IMPORTANT: Do not discard the rivets or pins.
10. Open the system tray. Refer to the “Opening the System Tray” section in this chapter.
11. Lift the PCI backplane up and out of the server.
Figure 2-42: Removing the PCI backplane
2-50 HP ProLiant ML570 Generation 2 Server Maintenance and Service Guide