User Manual

Removal and Replacement Procedures
Locking Casters
To remove the locking casters:
1. Prepare the server for a non-hot-plug procedure. Refer to “Preparing the Server for
Non-Hot-Plug Procedures” in this chapter.
2. Place the server on its side, and remove the three Torx T-15 screws securing each caster
to the chassis.
3. Pull the locking casters away from the server.
Figure 2-57: Removing the locking casters
Reverse steps 1 through 3 to replace the locking casters.
2-66 HP ProLiant ML570 Generation 2 Server Maintenance and Service Guide