Maintenance and Service Guide

Remove the antenna modules:
1. Remove the three Phillips PM2.0×2.75 screws (1) that secure the antenna modules to the
display panel assembly.
2. Detach the 3G antenna module (2) from the display panel assembly. (The 3G antenna module is
attached to the display panel assembly with double-sided adhesive.)
3. Detach the WiFi antenna module (3) from the display panel assembly. (The WiFi antenna module
is attached to the display panel assembly with double-sided adhesive.)
4. Remove the antenna modules.
Reverse this procedure to install the antenna modules.
Power button/microphone module
Description Spare part number
Power button/microphone module (includes cable, double-sided adhesive, and rubber pad) 744580-001
Before removing the power button/microphone module, follow these steps:
1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2. Disconnect the power from the tablet by unplugging the power cord from the tablet.
HP Slate7 HD
47