- Hewlett-Packard Network Card User Manual

Connecting to a Netware 4.1 server

Windows for Workgroups

Connecting to a Netware 4.1 server

Windows for Workgroups Requirements

• HP Vectra with DOS and MS-Windows for Workgroups 3.11 installed.

• 3COM Etherlink 3C905 Ethernet card and drivers disk ver 2.1.

• Vectra VL8 Driver name: 3C90X.LAN Size: 33KB Date: 2/5/98

• Vectra VL7 Driver name: EL90XIDS.INF Size: 2KB Date: 2/23/96

• DOS and MS-Windows for Workgroups 3.11 media.

• Novell Netware server that supports Net BEUI, NWLink IPX/SPX, and

• NWLink NetBIOS transfer protocols.

• 32-bit Netware client for DOS and MS-Windows.

Device Configuration

• Network Driver Optimization Normal

• Full Duplex Auto Select (N-Way)

• Boot PROM Disabled

• Media Type Auto Select (N-Way)

Procedure

1 With the HP Vectra turned off, install the 3COM Fast Etherlink 3C905

Vectra VL8 Vectra VL7

I/O Base Address FCC0h (PCI) FC40h (PCI)

Interrupt 9 (PCI) 9 (PCI)

905.bk : ch_3.fb4 Page 1 Thursday, October 22, 1998 9:51 AM