HP Elite x2 1012 G2 Tablet HP Elite x2 1012 G2 Tablet with Collaboration Keyboard - Maintenance and Service Guide

Hall sensor board
Description Spare part number
Hall sensor board 938108-001
IMPORTANT: Make special note of each screw and screw lock size and location during removal and
replacement.
Before removing the Hall eects sensor board, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Kickstand (select products only) (see Kickstand on page 26)
b. Back cover (see Back cover on page 29)
c. Display panel (see Display panel on page 30)
d. Battery (see Battery on page 32)
Remove the Hall sensor board:
1. Disconnect the cable (1) from the Hall sensor board.
2. Release the cable from the routing channels(2) securing the cable.
3. Remove the Phillips screw (3) securing the board.
4. Lift the board (4) to remove it.
Reverse this procedure to replace the Hall sensor board.
34 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts