HP Elite x2 1012 G2 Tablet HP Elite x2 1012 G2 Tablet with Collaboration Keyboard - Maintenance and Service Guide

CAUTION: Use care to prevent damaging the ZIF connector and ribbon cable.
2. Remove the micro SD card tray and the micro SIM card tray.
3. Lift the top edge of the system board (3), and then remove it.
Reverse this procedure to replace the system board.
POGO connector
Description Spare part number
POGO connector 938109-001
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Kickstand (select products only) (see Kickstand on page 26)
b. Back cover (see Back cover on page 29)
c. Display panel (see Display panel on page 30)
d. Battery (see Battery on page 32)
e. Hall sensor board (see Hall sensor board on page 34)
f. Kickstand hinges (see Kickstand hinges on page 35)
g. Solid-state drive (see Solid-state drive on page 36)
h. WLAN module (see WLAN module on page 38)
48 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts