HP Elite x2 1012 G2 Tablet HP Elite x2 1012 G2 Tablet with Collaboration Keyboard - Maintenance and Service Guide

i. WWAN module (see WWAN or GPS module (select products only) on page 40)
j. Webcam (see Webcam on page 42)
k. Microphone board (see Microphone board on page 43)
l. Rear webcam (see Rear webcam on page 45)
m. System board (see System board on page 47)
Remove the POGO connector:
▲
Disconnect the POGO cable from the system board (1), peel the cable up from the back cover (2),remove
2 screws from the POGO connector
(3), and then lift the connector to remove it (4).
Reverse this procedure to replace the fan.
Fan
Description Spare part number
Fan assembly 924448-001
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Kickstand (select products only) (see Kickstand on page 26)
b. Back cover (see Back cover on page 29)
c. Display panel (see Display panel on page 30)
d. Battery (see Battery on page 32)
e. Hall sensor board (see Hall sensor board on page 34)
Component replacement procedures 49