HP Elite x2 1012 G2 Tablet HP Elite x2 1012 G2 Tablet with Collaboration Keyboard - Maintenance and Service Guide

2. Release the speaker wires from the routing, and then lift the speakers to remove them.
Reverse this procedure to replace the speakers.
Antennas
Description Spare part number
Antennas, WLAN dual 925446-001
IMPORTANT: Make special note of each screw and screw lock size and location during removal and
replacement
Before removing the antennas, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Kickstand (select products only) (see Kickstand on page 26)
b. Back cover (see Back cover on page 29)
c. Display panel (see Display panel on page 30)
d. Battery (see Battery on page 32)
e. Hall sensor board (see Hall sensor board on page 34)
f. Kickstand hinges (see Kickstand hinges on page 35)
g. Solid-state drive (see Solid-state drive on page 36)
54 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts