HP SmartStream 3D Command Center 3.2 installation and troubleshooting guide

Technical Newsletter | HP SmartStream 3D Command Center 3.2 installation and troubleshooting guide
10
2) Click Security and select Manage password. If you cannot see this screen it is probably because a password has already
been set for it. In this case, go to step Error! Reference source not found.
3) Create the administrator password and click OK. It is very important to remember this password as it will be required to
access some settings, and for the future, if it is needed, to add the devices to Command Center again. If you forget this
password a Service intervention will be needed to reset it.
4) If the device already has a password set, you will see this screen: