HP SmartStream 3D Command Center 3.2 installation and troubleshooting guide

Technical Newsletter | HP SmartStream 3D Command Center 3.2 installation and troubleshooting guide
13
Log in to PrintOS
To make the process of adding a new device easier, you can log in to PrintOS beforehand. This way, when you need to add
a new device, you won’t be prompted with the PrintOS login.
As we can see in the image above, there is a new icon that represents the PrintOS login panel. If we click the button, a new
panel will be shown with a form where you can enter your PrintOS credentials. Note that the image above has a red circle
around the user: This means there is no user logged in. At any rate, a user can create a new account using the Create
account link. On the other hand, if a user does not remember his or her password, there is a Forgot Password? link to help
them reset it.
Once a user is logged in, the red circle around the login icon will disappear, and if we click the button again, the panel will
show information about the user:
Now, as we can see, the login form shows user information (basically his or her name and surname, and the email
address with which he or she is registered in PrintOS.
You can log out using the Sign Out link.