HP SmartStream 3D Command Center 3.2 installation and troubleshooting guide

Technical Newsletter | HP SmartStream 3D Command Center 3.2 installation and troubleshooting guide
14
Add device in Command Center
1) In Command Center Client, go to Settings > Device Management > Add device.
Note: If the button is disabled, check device connection to the Command Center Server in your notifications center, as
there should be a corresponding message.
2) Log in with your PrintOS Credentials.
This step is only needed if you are not logged into PrintOS. If this is the case, use the PrintOS login panel explained
previously. (If you try to add a new device without being logged in, you will first need to provide your PrintOS
credentials.) This window will be shown just once; the next time you need to add a new device, the Add device panel will
be shown directly.