HP SmartStream 3D Command Center 3.2 installation and troubleshooting guide

Technical Newsletter | HP SmartStream 3D Command Center 3.2 installation and troubleshooting guide
24
After this, a pop-up window appears. In the section corresponding to device management, the hostnames/IP addresses of
your 3D printers and Processing Stations should be listed. If the hostname/IP address doesn’t appear and there is a
disconnected icon, this means that Command Center can’t reach the device:
In this picture, 3D printers and Processing Stations are correctly connected:
Please delete the device by clicking the trash icon, then add it again using a hostname or static IP address. To do so, click
Add device at the bottom of the dialog box:
After this, the device should be listed in the dialog box again, now showing its IP address.