HP LaserJet Managed MFP E62655, E62665, E62675 - Installation Guide

7.1

7.3

7.2

7.1 Connect the power cable between the printer and a grounded AC outlet. 7.2 Turn on the printer, and then wait for it to initialize. 7.3 On the

control panel, set the language, the date/time format, and the time zone.

NOTE: For advanced conguration of network-connected printers, enter the printer IP address in the address bar of a web browser after software

installation is complete. To nd the IP address, select the Information button, and then select the Network

icon.

CAUTION: Make sure your power source is adequate for the printer voltage rating. The voltage rating is on the printer label. The printer uses either

100-127 Vac or 220-240 Vac and 50/60 Hz. To prevent damage to the printer, use only the power cable that is provided with the printer.

The high-speed USB port is disabled by default and must be

enabled from the printer control panel. Open the Settings menu,

and then select General > Enable Device USB > Enabled.

Windows: Do not connect the USB cable until prompted during

the software installation in the next step. If the network cable was

connected in step 6, proceed to step 9.

Mac: Connect the USB cable now.

NOTE: The cables are not included with the printer.