Software Suite for Microsoft Exchange User Manual

7.25
Recovery Manager Commands
3PAR Recovery Manager 4.1.0 For Microsoft Exchange 2010 User’s Guide
EXAMPLES
The following commands will release the lock at the Exchange server.
RMExch reset -s bottlenosed -opt lock
The following command will reset the existing mount status to available.
RMExch reset -mdb mydb1 -t 050106113456 -opt status
NOTE: When Recovery Manager is processing user requests, it will activate an
internal locking mechanism. Any incoming request will get “Server <ServerName>
has a Recovery Manager command running already” message. Please wait until it
finishes before continuing. However, in the case of unexpected termination, the
locking status might not get deactivated properly. You need to use this command
to release the lock for the operation to go back to normal status.