Software Suite for Oracle Instruction Manual

7.11
Periodic Database Synchronization
Recovery Manager for Oracle User’s Guide
7.7.1 Starting Periodic Synchronization
To start periodic synchronization on a Remote Copy node:
1 Right-click a Remote Copy node on the navigation tree and click Periodic Sync
Virtual Volumes.
The Periodic Synchronization Virtual Volumes screen appears.
2 Depending on the setup of your database, select either Online (Hot) Backup or Offline
(Cold) Backup and then click Finish.
After the periodic synchronization process is started, the command log view of the
Recovery Manager GUI displays a status of started.
7.7.2 Verifying the Periodic Synchronization Process
When starting periodic synchronization on a Remote Copy node, you may wish to verify that
the synchronization process is occurring.
X To verify the periodic synchronization on a Remote Copy node, right-click the Remote
Copy node where synchronization has started and click Periodic Sync Status.
A window appears displaying the status of the synchronization process.
7.7.3 Removing the Recovery Manager Periodic Sync Lock
Recovery Manager does not permit more than one periodic synchronization process for the
same database at a time. Recovery Manager uses the Periodic Sync Lock to prevent
simultaneous synchronization processes from occurring on a single database.
NOTE: Recovery Manager does not allow more than one periodic synchronization
process for the same database at the same time.