Software Suite for VMware User Manual

1. Click Edit.
The Edit Configuration dialog box appears (Figure 17 (page 34)).
Figure 17 vCenter Plug-in Configuration
NOTE: If you wish to change the values of the Recovery Manager server name or Recovery
Manager service TCP port properties under the Configuration tab, you must unregister the HP
3PAR Management Plug-in and Recovery Manager Software for VMware vSphere plug-in
from all vCenter Servers prior to the change; restart HP 3PAR Management Plug-in and Recovery
Manager for VMware vSphere Web Service; and reregister the vCenter Servers again after
the change. If the HP 3PAR Recovery Manager Administrator is assigned in the vCenter server,
the privilege will be lost when the plug-in is unregistered. The role will need to be reassigned.
:
If you encounter the following message, Could not create port binding. SSL
Certificate add failed, Error: 1312 A specified session does not
exist. It may already have been terminated. , while changing the port number,
refer to “Allowing Port Selections with Windows 2008 Installation” (page 25) to add permission
and remove an existing certificate. Rerun the Admin Tool to change the port number.
The fields available from the Configuration tab are shown in Table 1 (page 34).
Table 1 Configuration Tab Fields
DescriptionFieldGroup
The network host of the server where HP
3PAR Management Plug-in and Recovery
Recovery Manager server nameConfiguration
Manager Software for VMware vSphere is
installed. The vCenter Server and all
desktops running the vSphere client using
the HP 3PAR plug-in must be able to reach
this server. The name is used while
registering the HP 3PAR plug-in with the
vCenter Server.
The fully qualified name of the DNS name
of the running server is the default name.
The name can be changed to any name or
IP address.
The network port number that the
TpdVmWebService Web service uses. The
Recovery Manager service TCP port
default port is 9931 for secure connections.
This can be changed to any unused port.
34 Using the Admin Tool to Modify Configuration Settings