Software Owner's manual

• Scenario 3: Login failure on Hyper-V host.
RMH Server cannot authenticate with specified Hyper-V host.
• Scenario 4: Storage System session credentials are invalid.
Storage System session credentials provided are invalid.
• Scenario 5: Storage System credentials is already specified.
User is already logged in with specified Storage System.
• Scenario 6: Cannot start RMH session.
Failure occurred to start session. Reason displayed.
Add-StoreServ
Add-StoreServ is used for each HP 3PAR StoreServ credentials.
• HP 3PAR StoreServ credentials are associated to a specific Microsoft Hyper-V
• This command is only required to initially set up credentials. The command is persisted by
RMH Server until the user removes it.
• The user can Add/Remove/Update HP 3PAR StoreServ credentials at any time during the
session
Preconditions
• The user must first login with Login-Rmh.
• HP 3PAR StoreServ name must not already exist for specified Microsoft Hyper-V
Syntax
Any optional parameters require square brackets [ ] around them.
Add-StoreServ -RmhServerName <RmhServerName> -HypervName <HypervName>
-StoreServName <StoreServName> -StoreServUsername <StoreServUsername>
-StoreServPassword <StoreServPassword> [-Verbose]
Table 36 Add-StoreServ parameters
DescriptionOptional/RequiredParameter
Host name of the RMH Server. This is
FQDN or IP address.
Required-RmhServerName
This is FQDN or IP address. Synonyms
are supported. The localhost is not
supported.
Required-HypervName
This is FQDN or IP address, etc.
Synonyms for HP 3PAR StoreServ are
supported.
Required-StoreServName
Note, if not provided, a dialog box will
pop up asking for credentials.
Required-StoreServUsername
Note, if not provided, a dialog box will
pop up asking for credentials.
Required-StoreServPassword
Displays progress messagesOptional-Verbose
Add-StoreServ 63