Software Manual

B.9
controlport
InForm OS Version 2.3.1 Remote Copy User’s Guide
COMMAND
controlport
DESCRIPTION
The controlport command controls all aspects of a Fibre Channel or Remote Copy port,
including the port’s connection type and data rate. The controlport rcip and
controlport rcfc commands are required in setting up Remote Copy interfaces.
SYNTAX
The syntax for the controlport rcip and rcfc commands can be one of the following:
■ controlport config <connmode> [-ct <ctval>]
[-unique_nwwn enable|disable] [-f] <node:slot:port>...
■ controlport rst [-m <mode>|-l|-i] [-f] <node:slot:port>...
■ controlport offline <node:slot:port>...
■ controlport lip [-c <cagename>] [-f] <node:slot:port>...
■ controlport ct <ctval> [-f] <node:slot:port>...
■ controlport cl2 <cl2val> [-f] <node:slot:port>...
■ controlport rate <rateval> [-f] <node:slot:port>...
■ controlport vcn <vcnval> [-f] <node:slot:port>...
■ controlport nssync [-f] <node:slot:port>...
■ controlport intcoal <intcoalval> [-f] <node:slot:port>...
■ controlport rcip addr [-f] <IP_address> <netmask>
<node:slot:port>...
■ controlport rcip gw [-f] <gateway_address> <node:slot:port>...
■ controlport rcip delete [-f] <node:slot:port>...
■ controlport rcip mtu <MTU_size> <node:slot:port>...
■ controlport rcip state up|down [-f] <node:slot:port>...
■ controlport rcip speed <value> half|full <node:slot:port>...
■ controlport rcip speed auto <node:slot:port>...