Software Manual

B.15

controlport

InForm OS Version 2.3.1 Remote Copy User’s Guide

slot

Specifies the PCI bus slot in the specified node using a number from 0 to 6.

port

Specifies the Fibre Channel adaptor port number of the PCI card in the specified PCI

bus slot using

1 to 4.

<IP_address>

Specifies the IP address for a Remote Copy interface.

<gateway_address>

Specifies the gateway address for a Remote Copy interface.

Specifies the netmask for a Remote Copy interface.

<MTU_size>

Specifies the MTU size for a Remote Copy interface using an integer from 100 through

9000. If no integer is specified, the value defaults to 1500.

<speed> half|full

Use only with the rcip speed subcommand. Specifies the speed setting (10, 100, or 1000)

and duplex setting (half or full) for a Remote Copy interface. In addition to this specifier,

you must also specify an interface using <node:slot:port>. If no speed or duplex settings are

specified, or if you specify auto with the

rcip speed subcommand, the system auto-

negotiates the speed and duplex.

Specifies whether the port is used for a disk, host, or RCFC connection. This specifier must

be used when issuing the

config command.

RESTRICTIONS

■ See the InForm OS Command Line Interface Reference for a complete list of restrictions.

■ The controlport rcip addr command is only allowed for node/slot/port combinations

where there is an interface installed.