Software Manual

B.38
setrcopygroup
Remote Copy User’s Guide InForm OS Version 2.3.1
-local
When issuing the command with reverse as the value of the <dr_operation> specifier,
only the group’s direction is changed on the system where the command is issued.
-natural
When issuing the command with the reverse as the value of the <dr_operation>
specifier, only the natural direction of the groups is reversed, leaving the current direction
unchanged.
-current
When issuing the command with the reverse as the value of the <dr_operation>
specifier, only the current direction of the groups is reversed, leaving the natural direction
unchanged.
-waittask
Wait for all tasks created by the setrcopygroup command to complete before returning.
This option applies to the failover, recover, restore, and reverse
<dr_operation> specifier.
SPECIFIERS
<policy>
Specifies the policy to assign to the group. Valid policies are:
fail_wrt_on_err
Specifies that if Remote Copy is started for the volume group and a write to the
secondary system fails, then an I/O error is returned to the host.
no_fail_wrt_on_err
Specifies that if Remote Copy is started for the volume group and a write to the
secondary system fails, then the Remote Copy operation is stopped and an I/O error
is not returned to the host (default).
auto_recover
Specifies that if the Remote Copy is stopped as a result of the Remote Copy links
going down, the group will be restarted automatically after the links come back up.
If this policy is enabled for a group while the group is stopped after link failures it
will be only be started when the links come up for the failed target. If the links are
already up at the time the policy is set then the group will not be restarted at that
time.