Software Manual

B.44

setrcopytarget

Remote Copy User’s Guide InForm OS Version 2.3.1

enable|disable

Enables or disables the target.

OPTIONS

None.

SPECIFIERS

<target_name>

Specifies the target name for the target definition previously created with the

creatercopytarget command (see creatercopytarget on page B.20).

This specifier can only be used with the pol subcommand. The policy can be one of the

following:

mirror_config|no_mirror_config

Specifies that all configuration commands (creatercopygroup, removercopygroup,

admitrcopyvv, dismissrcopyvv, setrcopygroup pol/period,

startrcopygroup, and stoprcopygroup) involving the specified target are

duplicated (

mirror_config) or not duplicated (no_mirror_config). If not specified,

all configuration commands are duplicated.

<new_name>

The new name for the indicated target. This specifier can only be used with the name

subcommand.

<tput_value>

Specifies the maximum throughput for the indicated target's links, and is used to limit the

total throughput of the links. The throughput value can take a [

g|G] suffix (gigabytes), [m|M]

suffix (megabytes) or [k|K] suffix (kilobytes) to indicate size (with no space between the

specified value and size type). The default is kilobytes. Specifying a value of

0 removes the

throughput. This specifier can only be used with the

tput subcommand.

NOTE: The no_mirror_config specifier should only be used to allow recovery

from an unusual error condition and only used after consulting your 3PAR

representative.