Software Manual

B.52
showport
Remote Copy User’s Guide InForm OS Version 2.3.1
COMMAND
showport
DESCRIPTION
The showport command displays information about ports in the system.
SYNTAX
The syntax of the showport command can be one of the following:
■ showport [options] [-failed] [-sortcol <col>[,<dir>]]
AUTHORITY
Super, Service, Edit, Browse
OPTIONS
-i
Shows port hardware inventory information.
-c
Displays all devices connected to each loop (by position on the loop). Position 0 is the cage
connected directly to the node on this loop. Position n is the (n + 1) cage on the loop. Thus
a "pos" value of 1 means this cage is the second cage away from the node on the loop.
-par
Displays a parameter listing such as the configured data rate of a port and the maximum
data rate that the card supports. Also shown is the type of attachment (Direct Connect or
Fabric Attached) and whether the unique WWN and VCN capabilities are enabled.
-rc
Displays information that is specific to the Remote Copy ports.
-rcfc
Displays information that is specific to the Remote Copy Fibre Channel (RCFC) ports.
-rcip
Displays information specific to the Ethernet Remote Copy ports.
-iscsi
Displays information about iSCSI ports.